Luggage Oscillator Circuit
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The certification ECU activates the inner and outer luggage compartment oscillators. The power is supplied from the certification ECU to both the inner and outer luggage compartment oscillators. If the entry luggage compartment function has a problem, check both the inner and outer luggage compartment oscillator circuits.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ELECTRICAL KEY OSCILLATOR) |
Disconnect the E58 ECU connector.

Disconnect the oscillator connectors.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols)
Condition
Specified Condition
E58-16 (CG7B) - N25-3 (CLGB)
Always
Below 1 Ω
E58-15 (CLG7) - N25-1 (CLG6)
Always
Below 1 Ω
E58-32 (CG8B) - S14-2 (CLGB)
Always
Below 1 Ω
E58-31 (CLG8) - S14-1 (CLG5)
Always
Below 1 Ω
E58-16 (CG7B) - Body ground
Always
10 kΩ or higher
E58-15 (CLG7) - Body ground
Always
10 kΩ or higher
E58-32 (CG8B) - Body ground
Always
10 kΩ or higher
E58-31 (CLG8) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK AND REPLACE ELECTRICAL KEY OSCILLATOR |
Replace the electrical key oscillator.
Check that the luggage compartment door entry LOCK/UNLOCK function operates normally (outside oscillator) or the key confinement function operates normally (inside oscillator).
- OK:
- Luggage compartment door entry LOCK/UNLOCK function operates normally (outside oscillator) or the key confinement function operates normally (inside oscillator).
|
|
||||
| NG | |
| 3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Reconnect the oscillator and the ECU connectors.
Connect the intelligent tester to the DLC3.


Turn the engine switch on (IG).
Following the display on the tester, select "ACTIVE TEST".
Entry and Start (Certification ECU): Tester Display
Test Part
Control Range
Diagnostic Note
In Bdr Transmitter
Luggage compartment door inner oscillator
ON/OFF
-
Bdoor Transmitter
Luggage compartment door outer oscillator
ON/OFF
-
Measure the frequency according to the value(s) in the table below.

- Standard:
Tester Connection (Symbols)
Condition
Specified Condition
E58-16 (CG7B) - E58-15 (CLG7)
During ACTIVE TEST
Frequency is generated (higher than 0 Hz)
E58-32 (CG8B) - E58-31 (CLG8)
During ACTIVE TEST
Frequency is generated (higher than 0 Hz)
|
|
||||
| OK | ||
| ||
