The main body ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
Symbols (Terminal No.)
Terminal Description
Condition
Specified condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
CAN bus line
Engine switch off*
54 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Engine switch off*
200 Ω or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Engine switch off*
200 Ω or higher
CANH (6) - BAT (16)
HIGH-level CAN bus line
Engine switch off*
6 kΩ or higher
CANL (14) - BAT (16)
LOW-level CAN bus line
Engine switch off*
6 kΩ or higher
NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches or the doors.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
Connect the cable of the intelligent tester to the DLC3, turn the engine switch on (IG) and attempt to use the intelligent tester. If the screen displays a communication error message, a problem exists in the vehicle or in the tester.
If communication is normal when the tool is connected to another vehicle, inspect the DLC3 on the original vehicle.
If communication is still impossible when the tool is connected to another vehicle, the problem is probably in the tool itself. Consult the Service Department listed in the tool's instruction manual.