2006-2011 Camry Aurion · Service Manual SECURITIES

Security Horn Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

When the theft deterrent system is changed from the armed state to the alarm sounding state, the certification ECU can control the security horn.

WIRING DIAGRAM

B139452E03

INSPECTION PROCEDURE


1. INSPECT SECURITY HORN ASSEMBLY

  1. B139440
    Remove the security horn assembly.

  1. Check operation of the horn.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Horn sounds
    Battery negative (-) → Horn body



NG
REPAIR OR REPLACE SECURITY HORN ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (ENGINE ROOM J/B - SECURITY HORN ASSEMBLY)

  1. B139441E01
    Disconnect the 1A J/B connector and the A23 horn connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Terminal Connection
    Specified Condition
    1A-5 - A23-1
    Below 1 Ω
    1A-5 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE ROOM J/B)

  1. B139453E01
    Disconnect the E59 ECU connector and 1D J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Terminal Connection)
    Specified Condition
    SH- (E59-20) - (1D-11)
    Below 1 Ω
    SH- (E59-20) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (ENGINE ROOM J/B - BATTERY)

  1. B074501E16
    Disconnect the 1G J/B connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Terminal Connection
    Specified Condition
    1G-1 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Horn Circuit (from Jun 2009)Security Indicator Light Circuit (Oct 2006 – May 2009) →