Security Indicator Light Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
Even when the theft deterrent system is in the disarmed state, the security indicator blinks due to a signal output from the immobiliser system. The security indicator blinks continuously due to a continuous signal received from the immobiliser system while in the armed state.The certification ECU causes the security indicator to come on or blink only during the arming preparation state and alarm sounding states.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Press the intelligent tester main switch on.
Select the item below in the Active Test and then check that the indicator operates.
Smart (Certification ECU): Tester Display
Test Details
Diagnostic Note
Security Indicator
Security Indicator ON/OFF
-
- OK:
- The security indicator light flashes or goes off correctly when operating it through the intelligent tester.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - CERTIFICATION ECU) |
Disconnect the E58 ECU connector.

Disconnect the F3 clock connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Symbol (Tester Connection)
Specified Condition
IND (E58-2) - LP (F3-8)
Below 1 Ω
IND (E58-2) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Symbol (Tester Connection)
Specified Condition
GND1 (F3-11) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT CLOCK ASSEMBLY |
Reconnect the F3 clock connector.

Apply battery voltage between the terminals of the indicator, and check the lighting condition of the security indicator.
- Standard :
Measurement Condition
Specified Condition
Battery positive (+) → Terminal F3-8 (LP)
Battery negative (-) → Terminal F3-11 (GND1)
Security indicator comes on
- NOTICE:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
- Voltage of more than 12 V will damage the security indicator.
- If the voltage is too low, the security indicator will not come on.
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
|
|
||||
| OK | ||
| ||
