INSTALLATION
Removal / installation · Vehicles built from Jun 2009
| 1. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER |
Install the No. 2 ultrasonic sensor retainer to the rear bumper.

Text in Illustration *1
Snap
*2
Keyhole
- NOTICE:
- Do not damage the bumper with the snap when installing the retainer.
- HINT:
- When installing the retainer, align the keyhole and snap as shown in the illustration.
| 2. INSTALL NO. 2 ULTRASONIC SENSOR |
Engage the 2 claws and install the No. 2 ultrasonic sensor.

Connect each sensor connector.
Install the sensor retainer as shown in the illustration.

| 3. INSTALL REAR BUMPER ASSEMBLY (w/o Rear Lower Spoiler) |
Engage each claw.

Install the rear bumper assembly with the 6 screws and 2 clips.
Install the 2 rear bumper plates.

w/ Clearance Sonar System:
Install the grommet

Connect the connector.
| 4. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/o Rear Lower Spoiler) |
Install the rear quarter panel mudguard sub-assembly LH with the 3 screws.

| 5. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/o Rear Lower Spoiler) |
- HINT:
- Use the same procedure for the RH side and LH side.
| 6. INSTALL REAR BUMPER ASSEMBLY (w/ Rear Lower Spoiler) |
Engage each claw.

Install the rear bumper assembly with the 6 screws.
Install the 2 rear bumper plates.

w/ Clearance Sonar System:
Install the grommet

Connect the connector.
| 7. INSTALL REAR FLOOR BOARD (w/ Rear Lower Spoiler) |
Install the rear floor board with the 3 nuts, 2 clips and 4 screws.

| 8. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH |
Install the luggage compartment inner trim cover RH with the 2 clips.

| 9. INSTALL REAR FLOOR FINISH PLATE |
Engage the 7 clips and install the rear floor finish plate.

| 10. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
Install the 2 No. 1 luggage compartment trim hooks with the 2 screws.

| 11. INSTALL SPARE WHEEL COVER ASSEMBLY |
| 12. INSTALL SPARE WHEEL COVER CLAMP |
| 13. INSTALL LUGGAGE COMPARTMENT FLOOR MAT |
