REMOVAL
Removal / installation · Vehicles built from Jun 2009
| 1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT |
| 2. REMOVE SPARE WHEEL COVER CLAMP |
| 3. REMOVE SPARE WHEEL COVER ASSEMBLY |
| 4. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
Remove the 2 screws and the 2 No. 1 luggage compartment trim hooks.

| 5. REMOVE REAR FLOOR FINISH PLATE |
Disengage the 7 clips and remove the rear floor finish plate.

| 6. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH |
Remove the 2 clips and the luggage compartment inner trim cover RH.

| 7. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/o Rear Lower Spoiler) |
Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.

| 8. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/o Rear Lower Spoiler) |
- HINT:
- Use the same procedure for the RH side and LH side.
| 9. REMOVE REAR BUMPER ASSEMBLY (w/o Rear Lower Spoiler) |
w/ Clearance Sonar System:
Disconnect the connector.

Disengage the grommet.
Put protective tape around the rear bumper assembly.

Using a screwdriver, open the 2 rear bumper plates.

- HINT:
- Tape the screwdriver tip before use.
Remove the 6 screws and 2 clips.

Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

- HINT:
- Use the same procedure for the RH side and LH side.
Remove the rear bumper assembly.
| 10. REMOVE REAR FLOOR BOARD (w/ Rear Lower Spoiler) |
Remove the 4 screws, 2 clips, 3 nuts and rear floor board.

| 11. REMOVE REAR BUMPER ASSEMBLY (w/ Rear Lower Spoiler) |
w/ Clearance Sonar System:
Disconnect the connector.

Disengage the grommet.
Put protective tape around the rear bumper assembly.

Using a screwdriver, open the 2 rear bumper plates.

- HINT:
- Tape the screwdriver tip before use.
Remove the 6 screws.

Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

- HINT:
- Use the same procedure for the RH side and LH side.
Remove the rear bumper assembly.
| 12. REMOVE NO. 2 ULTRASONIC SENSOR |
Disconnect each sensor connector.
Remove the sensor retainer as shown in the illustration.

While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 2 ultrasonic sensor.

- HINT:
- The type of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.
| 13. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER |
Disengage the 2 claws and remove the No. 2 ultrasonic sensor retainer from the rear bumper.

