2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT BUMPER ASSEMBLY (for 2AZ-FE)

  1. B150435E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150437
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150439
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector, and then remove the front bumper assembly.


2. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)

  1. B161416
    Remove the 7 clips and cool air intake duct seal.


3. REMOVE FRONT BUMPER ASSEMBLY (for 2GR-FE)
without Headlight Cleaner System (Click here)
with Headlight Cleaner System (Click here)

4. REMOVE FOG LIGHT ASSEMBLY (for 2AZ-FE)

  1. E128199
    Remove the screw and the fog light assembly.


5. REMOVE FOG LIGHT ASSEMBLY (for 2GR-FE)

  1. E134242
    Remove the screw and the fog light assembly.

← REMOVAL (Jun 2006 – Sep 2006)REMOVAL (from Jun 2009) →