REMOVAL
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE FRONT BUMPER ASSEMBLY (for 2AZ-FE)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
w/o Fog Light:
Remove the front bumper assembly.
w/ Fog Light:
Disconnect each connector, and then remove the front bumper assembly.
| 2.
REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)
|
 |
- Remove the 7 clips and cool air intake duct seal.
| 3.
REMOVE FRONT BUMPER ASSEMBLY (for 2GR-FE)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 3 clips and 2 radiator grille protectors.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
w/ Clearance Sonar System:
Disconnect the 2 connectors.
w/ Fog Light:
Disconnect the 2 connectors.
w/ Headlight Cleaner System:
Disconnect the 2 connectors.
- Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.
Remove the front bumper assembly.
| 4.
REMOVE FOG LIGHT ASSEMBLY (for 2AZ-FE) |
 |
- Remove the screw and the fog light assembly.
| 5.
REMOVE FOG LIGHT ASSEMBLY (for 2GR-FE) |
 |
- Remove the screw and the fog light assembly.