REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
|
 |
- Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
| 2.
REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)
|
 |
- Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3.
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for LHD)
|
 |
- Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower No. 1 instrument panel finish panel.
| 4.
REMOVE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) (for LHD) |
 |
Disconnect all connectors.
- Remove the 2 nuts and the main body ECU (instrument panel junction block).
| 5.
REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
|
 |
- HINT:
- Use the same procedure for the RH side and the LH side.
| 6.
REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)
|
 |
- HINT:
- Use the same procedure for the RH side and the LH side.
| 7.
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for RHD)
|
 |
- Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower No. 1 instrument panel finish panel.
| 8.
REMOVE CLUTCH SWITCH ASSEMBLY |
 |
Disconnect the connector.
- Loosen the nut and remove the clutch switch assembly.