2006-2011 Camry Aurion · Service Manual CRUISE CONTROL SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)

  1. B132067
    Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

  1. B132116E01
    Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.


3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for LHD)

  1. B147264E01
    Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower No. 1 instrument panel finish panel.


4. REMOVE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) (for LHD)
  1. Disconnect all connectors.

  1. E128298
    Remove the 2 nuts and the main body ECU (instrument panel junction block).


5. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:
Use the same procedure for the RH side and the LH side.


6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

HINT:
Use the same procedure for the RH side and the LH side.


7. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for RHD)

  1. B158913E01
    Remove the bolt <D> and the screw <F>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect each connector, and then remove the lower No. 1 instrument panel finish panel.


8. REMOVE CLUTCH SWITCH ASSEMBLY
  1. Disconnect the connector.

  1. E131698E01
    Loosen the nut and remove the clutch switch assembly.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Jun 2006) →