2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE ENGINE UNDER COVER LH

2. REMOVE ENGINE UNDER COVER RH

3. REMOVE EXHAUST PIPE ASSEMBLY
(Click here)

4. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs, then drain the coolant.

    A128117E02

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


5. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil drain plug and drain the oil into a container.

  1. Clean the oil drain plug.

  1. Install the oil drain plug with a new gasket.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }


6. REMOVE NO. 2 MANIFOLD STAY

  1. A140783
    Remove the bolt, nut, and No. 2 manifold stay.


7. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

  1. A129640
    Remove the 3 bolts and No. 2 exhaust manifold heat insulator.


8. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

  1. A129641
    Uniformly loosen and remove the 6 nuts.

  1. Remove the manifold and gasket.


9. REMOVE ENGINE OIL COOLER

  1. A136291
    Remove the bolt, 2 clamps, and 4 clips and disconnect the 2 water by-pass hoses.

  1. A136292
    Remove the oil cooler union bolt, oil cooler assembly, and O-ring.

← COMPONENTS (from Oct 2006)REMOVAL (from Jun 2009) →