2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Open in One Side of CAN Branch Line

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

DESCRIPTION

If 2 or more ECUs and/or sensors do not appear on the intelligent tester "Communication Bus Check" screen, one side of the CAN branch wire may be open. (One side of the CAN-H [branch wire] / CAN-L [branch wire] of the ECU and/or sensor is open.)
Symptom
Trouble Area
2 or more ECUs and/or sensors do not appear on the intelligent tester "Communication Bus Check" screen.
  1. One side of the CAN branch wire is open
  2. Skid control ECU
  3. ECM
  4. Main body ECU
  5. A/C amplifier
  6. Center airbag sensor assembly
  7. Combination meter

WIRING DIAGRAM

C144951E03

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE
  1. Confirm the systems (ECUs and sensors), which use CAN communication, equipped on the vehicle. (Click here)

  1. Using the intelligent tester, select and perform "Communication Bus Check". (Click here) [*1]

  1. Disconnect the connectors from the ECUs or sensors that are not displayed on the screen. [*2]

  1. Check that only the ECUs and sensors from which the connectors were disconnected in the previous step are not displayed on the "Communication Bus Check" screen. [*3]

    HINT:
    If any ECUs or sensors, other than those from which the connectors were disconnected in the previous step, are not displayed on the "Communication Bus Check" screen, reconnect the disconnected connectors and repeat the procedures [*1], [*2], and [*3].

  1. Perform the communication stop mode check for the ECUs and sensors which correspond to the disconnected connectors. (Click here)


NEXT

GO TO CORRESPONDING COMMUNICATION STOP MODE


← Short to GND in CAN Bus Line (Jun 2006 – Sep 2006)PRECAUTION (Jun 2006 – Sep 2006) →