2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Jun 2006 – Sep 2006

RESULT LIST OF HOW TO PROCEED WITH TROUBLESHOOTING: 
Symptom
Suspected Area
See page
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in CAN Main Bus Wire"
Open in CAN Main Bus Line
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short in CAN Bus Wires"
Short in CAN Bus Line
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to B+ in CAN Bus Wire"
Short to B+ in CAN Bus Line
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to GND in CAN Bus Wire"
Short to GND in CAN Bus Line
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in One Side of CAN Branch Wire"
Open in One Side of CAN Branch Line
Click here
COMMUNICATION STOP MODE TABLE: 
Symptom
Suspected Area
See page
"ABS/VSC/TRC" is not displayed on the intelligent tester
Skid Control ECU Communication Stop Mode
Click here
"Air Conditioner" is not displayed on the intelligent tester
Air Conditioning Amplifier Communication Stop Mode
Click here
"Main Body" is not displayed on the intelligent tester
Main Body ECU Communication Stop Mode
Click here
"Engine" and "ECT" are not displayed on the intelligent tester
ECM Communication Stop Mode
Click here
"Combination Meter" is not displayed on the intelligent tester
Combination Meter ECU Communication Stop Mode
Click here
"SRS Airbag" is not displayed on the intelligent tester
Center Airbag Sensor Communication Stop Mode
Click here
← HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2006 – Sep 2006)TERMINALS OF ECU (Jun 2006 – Sep 2006) →