Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
The stereo jack adapter sends an external device sound signal to the navigation receiver assembly through this circuit.The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, navigation receiver assembly or speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO JACK ADAPTER) |
Disconnect the F38 navigation receiver assembly connector.
Disconnect the F44*1, F50*1 or E94*2 stereo jack adapter connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F38-19 (AUXI) - F44-4 (AUXI) or F50-4 (AUXI)*1
Always
Below 1 Ω
F38-18 (AGND) - F44-5 (AGND) or F50-5 (AGND)*1
Always
Below 1 Ω
F38-15 (ARI) - F44-2 (ARO) or F50-2 (ARO)*1
Always
Below 1 Ω
F38-17 (ALI) - F44-1 (ALO) or F50-1 (ALO)*1
Always
Below 1 Ω
F38-16 (ASGN) - F44-3 (ASGN) or F50-3 (ASGN)*1
Always
Below 1 Ω
F38-19 (AUXI) - E94-4 (AUXI)*2
Always
Below 1 Ω
F38-18 (AGND) - E94-5 (AGND)*2
Always
Below 1 Ω
F38-15 (ARI) - E94-2 (ARO)*2
Always
Below 1 Ω
F38-17 (ALI) - E94-1 (ALO)*2
Always
Below 1 Ω
F38-16 (ASGN) - E94-3 (ASGN)*2
Always
Below 1 Ω
F38-19 (AUXI) - Body ground
Always
10 kΩ or higher
F38-18 (AGND) - Body ground
Always
10 kΩ or higher
F38-15 (ARI) - Body ground
Always
10 kΩ or higher
F38-17 (ALI) - Body ground
Always
10 kΩ or higher
F38-16 (ASGN) - Body ground
Always
10 kΩ or higher
- *1: for 2AZ-FE
- *2: for 2GR-FE
|
|
||||
| OK | ||
| ||
