2006-2011 Camry Aurion · Service Manual ENGINE

B2289 Key Collation Waiting Time Over

Diagnostic trouble codes · Vehicles built from Jun 2009

DESCRIPTION

This DTC is output when there is a LIN communication problem between the main body ECU (instrument panel junction block assembly) and certification ECU (smart key ECU assembly) or when there is a problem in the entry function.
DTC No.
DTC Detection Condition
Trouble Area
B2289
Either condition below is met:
  1. LIN communication is abnormal between the main body ECU and the certification ECU (smart key ECU assembly)
  2. The engine immobiliser system is malfunctioning
  1. Main body ECU (instrument panel junction block assembly)
  2. Smart entry and start system (entry)
  3. Wire harness or connector
  4. Certification ECU (smart key ECU assembly)

WIRING DIAGRAM

B137989E27

INSPECTION PROCEDURE

HINT:
When the main body ECU (instrument panel junction block assembly) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block assembly) is replaced, perform the registration procedures for the engine immobiliser system.


1. CHECK FOR DTCS
  1. Clear the DTCs (Click here).

  1. Check for DTC B2289 (Key collation waiting time over) and B2785 (Communication malfunction between ECUs connected by LIN).

    Result:
    Display (DTC output)
    Proceed to
    "DTC B2289" only
    A
    "DTC B2785" only
    B
    No DTC
    C

    HINT:
    1. If DTC B2785 is output, perform troubleshooting for DTC B2785 first (Click here).



B
GO TO DTC B2785 (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
  1. Disconnect the E58 and IR connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    IR-9 (LIN1) - E58-10 (LIN)
    Always
    Below 1 Ω
    IR-9 (LIN1) or E58-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
OK


3. CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) OPERATION
  1. After replacing the main body ECU (instrument panel junction block assembly) with a normally functioning ECU, check that the engine starts.

    OK:
    Engine can start normally.

    HINT:
    If the engine does not start, refer to Problem Symptoms Table of the smart entry and start system (entry) (matching for the inside of the cabin cannot be performed) (Click here).



NG
GO TO SMART ENTRY AND START SYSTEM (ENTRY) (Click here)
OK

END (MAIN BODY ECU WAS DEFECTIVE)


← B2288 Steering Lock Signal Circuit Malfunction (from Jun 2009)Engine does not Start (from Jun 2009) →