2006-2011 Camry Aurion · Service Manual ENGINE

B2288 Steering Lock Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

DESCRIPTION

This DTC is output when the main body ECU (instrument panel junction block assembly) cannot detect the unlock condition of the steering lock within a specified time.
DTC No.
DTC Detection Condition
Trouble Area
B2288
After turning engine switch from off to on (IG), the steering wheel does not unlock for a certain period of time (ECU unlocks steering wheel only when it receives an unlock signal from LIN communication and cable)
  1. Main body ECU (instrument panel junction block assembly)
  2. Steering lock ECU (steering lock actuator assembly)
  3. Wire harness or connector

WIRING DIAGRAM

B112452E67

INSPECTION PROCEDURE

HINT:
When the main body ECU (instrument panel junction block assembly) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block assembly) is replaced, perform the registration procedures for the engine immobiliser system.


1. CHECK FOR DTCS
  1. Clear the DTCs (Click here).

  1. After all DTCs are cleared, check if the trouble occurs again 5 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    DTC B2785 (Communication malfunction between ECUs connected by LIN), DTC B2287 (LIN communication master malfunction) and DTC B2781 (Open/short in steering lock ECU (steering lock actuator assembly)) are not output.

    HINT:
    1. If DTC B2785 is output (Click here).
    2. If DTC B2287 is output (Click here).
    3. If DTC B2271 is output (Click here).



NG
GO TO DTC CHART
OK


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - STEERING LOCK ECU)
  1. Disconnect the E7 and E51 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-18 (SLP) - E51-4 (SLP1)
    Always
    Below 1 Ω
    E7-18 (SLP) or E51-4 (SLP1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) OPERATION
  1. After replacing the main body ECU (instrument panel junction block assembly) with a normally functioning ECU, check that the steering lock/unlock function operates normally.

    OK:
    Steering lock/unlock function operates normally.



NG
GO TO ELECTRIC STEERING LOCK (Click here)
OK

END (MAIN BODY ECU WAS DEFECTIVE)


← B2287 LIN Communication Master Malfunction (from Jun 2009)B2289 Key Collation Waiting Time Over (from Jun 2009) →