2006-2011 Camry Aurion · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. INSTALL ENGINE REAR OIL SEAL

  1. A132245E01
    Apply MP grease to a new oil seal lip.

  1. Using SST and a hammer, tap in the oil seal.

    SST
    09223-15030  
    09950-70010   (09951-07150)

    Oil seal tap in depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)


2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A129631E01
    Using SST, hold the crankshaft.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. P000601E04
    Apply adhesive to 2 or 3 threads of the mounting bolt end.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. A132243E01
    Install the front spacer, drive plate and rear spacer on the crankshaft.

  1. Install and tighten the 8 mounting bolts uniformly in several steps.

    Torque:
    83 N*m{ 850 kgf*cm , 61 ft.*lbf }


3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
Click here.

← INSTALLATION (Oct 2006 – May 2009)PRECAUTION (Jun 2006 – May 2009) →