2006-2011 Camry Aurion · Service Manual TRANSMISSION

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

When the ignition switch is turned on (IG), voltage from the ECM's MREL terminal is applied to the EFI relay. This causes the contacts of the EFI relay to close, which supplies power to terminal +B of the TCM.

WIRING DIAGRAM

C133264E01

INSPECTION PROCEDURE


1. INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL)

  1. C133210E27
    Disconnect the TCM connector.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    +B (C56-18) - Body ground
    9 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - EFI RELAY)
OK


2. CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)

  1. C133210E07
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E1 (C56-8) - Body ground
    Below 1 Ω

  1. Reconnect the TCM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BODY GROUND)
OK

REPLACE TCM


← Park / Neutral Position Switch Circuit (from Oct 2006)ADJUSTMENT (from Oct 2006) →