INSTALLATION
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL AMPLIFIER ANTENNA ASSEMBLY |
 |
- Install the amplifier antenna assembly with the bolt.
Connect each connector.
| 2.
INSTALL ROOF SIDE INNER GARNISH RH |
 |
- HINT:
- Use the same procedures for the RH side and the LH side (Click here).
| 3.
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
|
 |
- Install the rear door opening trim weatherstrip RH as shown in the illustration.
- NOTICE:
- After installation, check that the corners fit correctly.
| 4.
INSTALL REAR DOOR SCUFF PLATE RH |
 |
- HINT:
- Use the same procedure for the RH side and the LH side (Click here).
| 5.
INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) |
 |
- HINT:
- Use the same procedure for the RH side and the LH side (Click here).
| 6.
INSTALL SEPARATE TYPE REAR SEATBACK ASSEMBLY RH (for Fold Down Seat Type)
|
 |
- Install the separate type rear seatback assembly with the 2 bolts.
-
Torque:
- 18 N*m{
184 kgf*cm
, 13 ft.*lbf
}
| 7.
INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
|
 |
- Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.
Confirm that the seat cushion is firmly installed.
- NOTICE:
- When installing the bench type rear seat cushion assembly, make sure that the seat belt buckle is not under the bench type rear seat cushion assembly.
| 8.
INSTALL REAR SEATBACK ASSEMBLY (for Fixed Seat Type)
|
 |
- Place the seatback in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
Install the rear seatback assembly with the 4 bolts.
-
Torque:
- 18 N*m{
184 kgf*cm
, 13 ft.*lbf
}
- Pass the 3 seat belts through and close the cap of the 2 rear seat shoulder belt guides.
Install the floor anchor part with the bolt.
| 9.
INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)
|
 |
- Attach the 2 front hooks of the seat cushion to the vehicle body.
Confirm that the seat cushion is firmly installed.
- NOTICE:
- When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.
| 10.
INSTALL REAR CENTER SEAT HEADREST ASSEMBLY (w/ Center Headrest) |
|
| 11.
INSTALL REAR SEAT HEADREST ASSEMBLY |
|