REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
 |
- Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.
| 2.
REMOVE UPPER CONSOLE PANEL FRONT GARNISH
|
 |
- Apply protective tape to the area shown in the illustration.
- Using a moulding remover, disengage the 3 claws as shown in the illustration.
- Using a moulding remover, disengage the 3 claws and remove the upper console panel front garnish as shown in the illustration.
Disconnect each connector.
| 3.
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
- Apply protective tape to the area shown in the illustration.
- Using a moulding remover, disengage the 2 claws as shown in the illustration.
- Apply protective tape to the area shown in the illustration.
- Using a moulding remover, disengage the 2 claws as shown in the illustration.
- Disengage the 6 claws and remove the upper console panel sub-assembly as shown in the illustration.
Disconnect the connector.
| 4.
REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY
|
 |
- Apply protective tape to the areas shown in the illustration.
- Using a moulding remover, disengage the 6 claws as shown in the illustration.
- Using a moulding remover, disengage the 5 claws as shown in the illustration.
Disconnect each connector and remove the instrument panel No. 2 register assembly.
| 5.
REMOVE RADIO RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY |
 |
- Remove the 4 bolts.
Pull the radio receiver with heater control panel assembly toward the rear of the vehicle and disengage the 4 clips.
Disconnect each connector and remove the radio receiver with heater control panel assembly.
| 6.
REMOVE RADIO NO. 1 BRACKET |
 |
- Remove the 3 bolts, 2 screws and radio No. 1 bracket.
| 7.
REMOVE RADIO NO. 2 BRACKET |
 |
- Remove the 3 bolts, 2 screws and radio No. 2 bracket.
| 8.
REMOVE RADIO RECEIVER ASSEMBLY |
 |
- Remove the radio receiver assembly as shown in the illustration.