REMOVAL
Removal / installation · Vehicles built from Jun 2006
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 3.
REMOVE ENGINE UNDER COVER RH |
|
| 4.
REMOVE FRONT FENDER APRON SEAL RH |
|
| 5.
REMOVE V-RIBBED BELT
|
 |
- Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
- SST
- 09216-42010
- NOTICE:
- Be sure to connect SST and the tools so that they are in line during use.
- When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
- After the tensioner is fully retracted, do not apply more force than necessary.
| 6.
REMOVE GENERATOR ASSEMBLY |
 |
- Disconnect the generator connector.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and wire harness clamp bracket.
Remove the wire harness clamp.
- Remove the 2 bolts and generator assembly.