DISASSEMBLY
Removal / installation · Vehicles built Jun 2006 – May 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| 1.
REMOVE GENERATOR PULLEY |
 |
- SST
- 09820-63010
(09820-06020, 09820-06010)
Item
|
Part No.
|
SST 1-A and B
|
09820-06010
|
SST 2
|
09820-06020
|
- While holding SST 1-A with a torque wrench, tighten SST 1-B clockwise to the specified torque.
-
Torque:
- 39 N*m{
400 kgf*cm
, 29 ft.*lbf
}
- NOTICE:
- Check that the SST is secured to the rotor shaft.
Mount SST 2 in a vise.
- Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.
To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
- NOTICE:
- To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.
Remove the generator from SST 2.
- While holding SST 1-B, turn SST 1-A and remove SST 1-A and 1-B.
Remove the pulley nut, then remove the generator pulley.
| 2.
REMOVE GENERATOR REAR END COVER |
 |
- Remove the 3 nuts and rear end cover.
| 3.
REMOVE GENERATOR TERMINAL INSULATOR |
 |
- Remove the terminal insulator.
| 4.
REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
 |
- Remove the 2 screws and generator brush holder.
| 5.
REMOVE GENERATOR ROTOR ASSEMBLY |
 |
- Remove the 4 bolts.
- Remove the bolt and cord clip.
- Using SST, remove the coil.
- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
| 6.
REMOVE GENERATOR ROTOR ASSEMBLY |
 |
- Remove the washer.
- Remove the generator rotor.
| 7.
REMOVE GENERATOR DRIVE END FRAME BEARING |
 |
- Remove the 4 screws and bearing retainer.
- Using SST and a hammer, tap out the bearing.
- SST
- 09950-60010
(09951-00250)
09950-70010
(09951-07100)