2006-2011 Camry Aurion · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2006


1. INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

  1. C138512
    Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.


2. REMOVE STATOR SHAFT ASSEMBLY

  1. C138275
    Using a "TORX" wrench (T30), remove the 16 bolts and stator shaft assembly from the oil pump body.

    NOTICE:
    Keep the gears in the order of installation.


3. INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

  1. C138509
    Push the driven gear to one side of the body.

  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    0.08 to 0.15 mm (0.0031 to 0.0059 in.)

    Maximum clearance:
    0.15 mm (0.0059 in.)

    If the clearance is greater than the maximum, replace the oil pump body sub-assembly.

  1. C138511
    Using a straight edge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.025 to 0.04 mm (0.0010 to 0.0016 in.)


    Maximum side clearance:
    0.04 mm (0.0016 in.)
    Drive gear thickness: 
    Mark
    Thickness
    -
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    -
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    -
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    -
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    -
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)
    Driven gear thickness: 
    Mark
    Thickness
    -
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    -
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    -
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    -
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    -
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)


4. REMOVE FRONT OIL PUMP BODY O-RING

  1. C138278
    Remove the O-ring from the oil pump body.


5. REMOVE FRONT OIL PUMP DRIVE GEAR

  1. C138276
    Remove the front oil pump drive gear from the oil pump body.


6. REMOVE FRONT OIL PUMP DRIVEN GEAR

  1. C138277
    Remove the front oil pump driven gear from the oil pump body.


7. REMOVE FRONT OIL PUMP OIL SEAL

  1. C138508E01
    Mount the oil pump in a soft jaw vise.

  1. Using SST, remove the oil seal from the oil pump body.

    SST
    09308-00010  

← COMPONENTS (from Oct 2006)INSPECTION (from Oct 2006) →