2006-2011 Camry Aurion · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Oct 2006


INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

  1. C138512
    Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.


INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

  1. C138509
    Push the driven gear to one side of the body.

  1. Using a feeler gauge, measure the clearance.

    Standard clearance:
    0.08 to 0.15 mm (0.0031 to 0.0059 in.)

    Maximum clearance:
    0.15 mm (0.0059 in.)

    If the clearance is greater than the maximum, replace the oil pump body sub-assembly.

  1. C138511
    Using a straight edge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.025 to 0.04 mm (0.0010 to 0.0016 in.)


    Maximum side clearance:
    0.04 mm (0.0016 in.)
    Drive gear thickness: 
    Mark
    Thickness
    -
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    -
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    -
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    -
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    -
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)
    Driven gear thickness: 
    Mark
    Thickness
    -
    11.547 to 11.555 mm (0.4546 to 0.4549 in.)
    -
    11.555 to 11.563 mm (0.4549 to 0.4552 in.)
    -
    11.564 to 11.571 mm (0.4553 to 0.4556 in.)
    -
    11.572 to 11.579 mm (0.4556 to 0.4559 in.)
    -
    11.580 to 11.587 mm (0.4559 to 0.4562 in.)


INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

  1. C138514
    Using a dial indicator, measure the inside diameter of the oil pump body bushing.

    Standard inside diameter:
    43.113 to 43.138 mm (1.6974 to 1.6983 in.)

    Maximum inside diameter:
    43.188 mm (1.7003 in.)

    If the inside diameter is greater than the maximum, replace the oil pump body sub-assembly.


INSPECT STATOR SHAFT ASSEMBLY

  1. C138513
    Using a dial indicator, measure the inside diameter of the oil pump body bushing.

    Standard inside diameter:
    22.500 to 22.526 mm (0.8858 to 0.8868 in.)

    Maximum inside diameter:
    22.570 mm (0.8886 in.)

    If the inside diameter is greater than the maximum, replace the oil pump body sub-assembly.

← DISASSEMBLY (from Oct 2006)REASSEMBLY (from Oct 2006) →