2006-2011 Camry Aurion · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2006


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. C138515E01
    Using SST and a hammer, install a new oil seal to the oil pump body.
    SST
    09350-32014   (09351-32140)

    NOTICE:
    The seal end should be level with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with MP grease.


2. INSTALL FRONT OIL PUMP BODY O-RING

  1. C138278
    Coat a new O-ring with ATF and install it to the oil pump body.

    NOTICE:
    Ensure that the O-ring is not twisted.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

  1. C138277
    Coat the front oil pump driven gear with ATF and install it to the oil pump body with the marked side up.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

  1. C138276
    Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.


5. INSTALL STATOR SHAFT ASSEMBLY

  1. C138275E01
    Align each knock pin of the stator shaft with the holes in the oil pump body and install the stator shaft to the oil pump body with the 16 bolts.

  1. Using a "TORX" socket (T30), install the 11 bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

    -
    -
    Bolt length:
    Bolt length:
    Bolt A
    Bolt A
    14 mm (0.55 in)
    Bolt B
    Bolt B
    26 mm (1.02 in)


6. INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

  1. C138512
    Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.

← INSPECTION (from Oct 2006)COMPONENTS (from Oct 2006) →