2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clock Display Circuit

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

In this circuit, the clock assembly receives auto dimmer signals from the main body ECU using the direct line. When the clock assembly receives an auto dimmer signal, it dims the clock illumination. The main body ECU determines whether it is daytime, twilight, or nighttime based on the waveform transmitted from the automatic light control sensor. If the main body ECU determines that it is daytime, the ECU does not send auto dimmer signals. Therefore, the clock illumination (warning and indicator lights) will not dim even if the driver accidentally turns the light control switch to the TAIL or HEAD position in daytime.

HINT:
If there is a malfunction in automatic light control sensor, DTC B1244 is output (Click here).


WIRING DIAGRAM

E128067E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - MAIN BODY ECU)

  1. E128073E02
    Disconnect the E6 and F3 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E6-16 (ACAN) - F3-4 (ILL+)
    Always
    Below 1 Ω
    F3-4 (ILL+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT MAIN BODY ECU
  1. Reconnect the E6 connector.

  1. E128063E09
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F3-4 (ILL+) - Body ground
    Ignition switch on (IG), cover the automatic light control sensor by hand, and light control switch TAIL/HEAD
    10 to 14 V



NG
GO TO LIGHTING SYSTEM
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Clock Loses or Gains Time (from Jun 2006)Clock Display Circuit (Oct 2006 – May 2009) →