2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSPECTION

Inspection · Vehicles built from Oct 2006


INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)

  1. E005280
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    (at 20°C (68°F))
    160 to 320 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID)

  1. E116970E04
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 1
    20°C (68°F)
    10 to 11 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT COMPRESSOR AND MAGNETIC CLUTCH

  1. E005280E18
    Disconnect the connector from the compressor and magnetic clutch.

  1. E124482E03
    Disconnect the connector from the magnetic clutch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A-3 - B-1
    Always
    Below 1 Ω
    A-3 - Body ground
    Always
    10 kΩ or higher

    If the resistance is not as specified, replace the compressor and magnetic clutch.


INSPECT MAGNETIC CLUTCH

  1. E113611E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    20 °C (68°F)
    3.8 to 4.2 Ω

    If the resistance is not as specified, replace the magnetic clutch.

  1. When connector terminal 1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.

    OK:
    1):
    The magnetic clutch's operating sound can be heard.
    2):
    The magnetic clutch's hub and rotor lock.

    If the result is not as specified, replace the magnetic clutch.

← DISASSEMBLY (from Oct 2006)REASSEMBLY (from Oct 2006) →