2006-2011 Camry Aurion · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B232362
    Remove the 7 clips and cool air intake duct seal.


2. REMOVE FRONT BUMPER ASSEMBLY

  1. B232367E01
    Put protective tape around the front bumper assembly.

  1. B149626E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B232368
    Remove the 8 screws, 3 clips and 2 radiator grille protectors.

  1. B232369
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. w/ Clearance Sonar System:

    1. Disconnect the 2 connectors.

  1. w/ Fog Light:

    1. Disconnect the 2 connectors.

  1. w/ Headlight Cleaner System:

    1. Disconnect the 2 connectors.

    2. B149621
      Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.

  1. Remove the front bumper assembly.

← REMOVAL (Oct 2006 – May 2009)DISASSEMBLY (Oct 2006 – May 2009) →