Microphone Circuit between Microphone and Navigation Receiver Assembly
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This circuit sends a microphone signal from the microphone to the navigation receiver assembly.It also supplies power from the navigation receiver assembly to the microphone.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (MICROPHONE - NAVIGATION RECEIVER ASSEMBLY) |
Disconnect the microphone connector Q15 and navigation receiver assembly connector F12.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
Q15-1 (ACC) - F12-17 (MACC)
Always
Below 1 Ω
Q15-3 (MI1+) - F12-19 (MIC+)
Always
Below 1 Ω
Q15-5 (MIC-) - F12-20 (MIC-)
Always
Below 1 Ω
F12-17 (MACC) - Body ground
Always
10 kΩ or higher
F12-19 (MIC+) - Body ground
Always
10 kΩ or higher
F12-20 (MIC-) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. INSPECT NAVIGATION RECEIVER ASSEMBLY |
Reconnect the navigation receiver assembly connector F12.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
F12-17 (MACC) - Body ground
Ignition switch on (ACC)
4 to 6 V
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR |
Disconnect the navigation receiver assembly connector F12.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
F12-18 (SGND) - F12-12 (TSW-)
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
