Microphone Circuit between Microphone and Navigation Receiver Assembly
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.It also supplies power from the navigation receiver assembly to the telephone microphone assembly.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT NAVIGATION RECEIVER ASSEMBLY |
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
F12-17 (MACC) - Body ground
Ignition switch on (ACC)
4 to 6 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F12-18 (SGND) - Body ground
Always
Below 1 Ω
F12-20 (MIC-) - Body ground
Always
Below 1 Ω
- Result:
Result
Proceed to
OK
A
NG
(for 2GR-FE RHD)
B
NG
(except 2GR-FE RHD)
C
Text in Illustration *1
Component with harness connected
(Navigation Receiver Assembly)
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY) |
Disconnect the F12 navigation receiver assembly connector.
Disconnect the Q15*1 or Q17*2 telephone microphone assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F12-5 (SNS2) - Q15-4 (SNS2)*1
Always
Below 1 Ω
F12-17 (MACC) - Q15-1 (ACC)*1
Always
Below 1 Ω
F12-19 (MIC+) - Q15-3 (MI1+)*1
Always
Below 1 Ω
F12-20 (MIC-) - Q15-5 (MIC-)*1
Always
Below 1 Ω
F12-5 (SNS2) - Q17-4 (SNS2)*2
Always
Below 1 Ω
F12-17 (MACC) - Q17-1 (ACC)*2
Always
Below 1 Ω
F12-19 (MIC+) - Q17-3 (MI1+)*2
Always
Below 1 Ω
F12-20 (MIC-) - Q17-5 (MIC-)*2
Always
Below 1 Ω
F12-5 (SNS2) - Body ground
Always
10 kΩ or higher
F12-17 (MACC) - Body ground
Always
10 kΩ or higher
F12-19 (MIC+) - Body ground
Always
10 kΩ or higher
F12-20 (MIC-) - Body ground
Always
10 kΩ or higher
F12-18 (SGND) - Body ground
Always
10 kΩ or higher
- *1: w/ Sliding Roof
- *2: w/o Sliding Roof
|
|
||||
| OK | |
| 3. INSPECT TELEPHONE MICROPHONE ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
Q15-4 (SNS2) - Q15-5 (MIC-)*2
Always
Below 1 Ω
Q17-4 (SNS2) - Q17-5 (MIC-)*3
Always
Below 1 Ω
Text in Illustration *1
Component without harness connected
(Telephone Microphone Assembly)
- *2: w/ Sliding Roof
- *3: w/o Sliding Roof
|
|
||||
| OK | ||
| ||
