2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Navigation Receiver Assembly Power Source Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM

E121223E20

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E137742E02
    Disconnect the navigation receiver assembly connector F36.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F36-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F36-4 (B) - F36-7 (GND)
    Always
    10 to 14 V
    F36-3 (ACC) - F36-7 (GND)
    Ignition switch on (ACC)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Navigation Receiver Assembly Power Source Circuit (Jun 2006 – Sep 2006)Navigation Receiver Assembly Power Source Circuit (from Jun 2009) →