2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Navigation Receiver Assembly Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM

E192525E02

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY
  1. Disconnect the F36 navigation receiver assembly connector.

  1. Disconnect the F13 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F36-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F36-4 (B) - F36-7 (GND)
    Always
    11 to 14 V
    F36-3 (ACC) - F36-7 (GND)
    Ignition switch on (ACC)
    11 to 14 V
    F13-2 (IG) - F36-7 (GND)
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Navigation Receiver Assembly Power Source Circuit (Oct 2006 – May 2009)COMPONENTS (Jun 2006 – Sep 2006) →