2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

No GSM Signal

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The mayday ECU controls both the GPS and GSM antennas, which are located on the rear parcel tray.
The GSM antenna is capable of transmitting and receiving both voice and data signals via the GSM network. The GSM antenna must not be obscured by any objects such as underground car parks, tunnels, bridges, buildings, objects on the parcel tray or after market window tinting; any of these may affect GSM signal strength. In most cases however, as the vehicle emerges from the obstruction or reenters the digital phone network area, the signal will be available again and any stored data will be transmitted.
The GSM antenna is connected to the mayday ECU by a push on type connector.

INSPECTION PROCEDURE


1. CHECK GSM MODULE
  1. Using the TDT, select System Menu / Diagnosis / Data List.

  1. Scroll to GSM module.

  1. Is the GSM module display "Active"?



NO
Go to step 4
YES


2. CHECK GSM ANTENNA CONNECTION
  1. Check the connector retention of the GSM connector.

  1. Is the connector retention OK?



NO
REPAIR OR REPLACE THE CONNECTOR
YES


3. CHECK GSM ANTENNA
  1. Temporarily install a known good GSM antenna.

  1. Using the TDT, select System Menu / Diagnosis / Data List.

  1. Scroll to GSM signal strength.

  1. Does the GSM show active?



YES
REPLACE THE GSM ANTENNA
NO


4. CHECK MAYDAY ECU GSM HARNESS
  1. Disconnect the GSM antenna connector D1 and mayday ECU GSM connector.

  1. Check for continuity of the GSM harness.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE GSM HARNESS
OK


5. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← No GPS Signal (from Oct 2006)Microphone (from Oct 2006) →