Microphone
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
The active microphone in the roof console box provides a means for two-way voice communication between the vehicle occupants and Toyota Link Call Centre.INSPECTION PROCEDURE
| 1. CHECK MICROPHONE VOLTAGE |
Disconnect the roof console box connector Q16.

Connect a digital multimeter between terminal 4 and ground.
Turn the engine switch on (IG) and check for voltage.
- Standard:
- 5.0 V
Is the voltage as specified?
|
|
||||
| NO | |
| 2. CHECK MICROPHONE VOLTAGE |
Connect a digital multimeter between terminal 4 and ground.

Turn the engine switch on (IG) and check for voltage.
- Standard:
- 5.0 V
Is the voltage greater than specified?
|
|
||||
| NO | |
| 3. CHECK MICROPHONE VOLTAGE AT THE MAYDAY ECU |
Disconnect the mayday ECU unit connector N46.

Connect a digital multimeter between terminal 12 and ground.
Turn the engine switch on (IG).
Measure the voltage.
- OK:
- 5.0 V
|
|
||||
| NG | |
| 4. CHECK THE CONTINUITY OF THE WIRE HARNESS |
Disconnect the roof console box connector Q16 and the mayday ECU unit connector N46.

Connect a digital multimeter between connector Q16 terminal 2 and connector N46 terminal 18.
Check for continuity.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 5. CHECK ROOF CONSOLE BOX CONNECTOR |
Is the roof console box connector tight?
|
|
||||
| YES | |
| 6. CHECK MAYDAY ECU WIRE HARNESS |
Disconnect the mayday ECU connectors A and B.

Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 7. CHECK MAYDAY ECU CONNECTORS |
Are the mayday ECU connectors tight?
|
|
||||
| YES | ||
| ||
