2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL4 CAN Comms Failure

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The mayday ECU monitors the centre airbag sensor assembly on terminal GSW, and the CAN Bus for messages.
If the mayday ECU is able to monitor the CAN Bus for messages successfully, the CAN Bus is considered healthy. If the mayday ECU is unable to monitor the CAN Bus for messages but can monitor the centre airbag sensor signal successfully, the CAN Bus is considered unhealthy.
DTC TL4 is set if the mayday ECU monitors no CAN communications for 10 seconds while the centre airbag sensor signal is healthy.

INSPECTION PROCEDURE


1. CHECK CONTINUITY OF MAYDAY ECU AND WIRE HARNESS

  1. B169476E01
    Connect a digital multimeter between mayday ECU unit connector N46 terminal 1 and ground and check for continuity.

    OK:
    Less than 1 Ω



OK
Go to step 3
NG


2. CHECK CONTINUITY OF MAYDAY ECU

  1. B169477E01
    Disconnect the mayday ECU connector B.

  1. Connect a digital multimeter between terminal 5 and ground and check for continuity.

    OK:
    Less than 1 Ω



NG
REPLACE THE MAYDAY ECU
OK


3. CHECK CONTINUITY OF MAYDAY ECU AND WIRE HARNESS

  1. B169476E01
    Connect a digital multimeter between mayday ECU unit connector N46 terminal 2 and ground and check for continuity.

    OK:
    Less than 1 Ω



OK
REPLACE MAYDAY ECU
NG


4. CHECK GROUND CONTINUITY

  1. B169477E01
    Disconnect the mayday ECU connector B.

  1. Connect a digital multimeter between terminal 5 and ground and check for continuity.

    OK:
    Less than 1 Ω



NG
REPLACE THE MAYDAY ECU
OK

REPLACE MAYDAY ECU


← TL39 Vehicle Identification Number Mismatch (from Jun 2009)TL40 Volume Up Button Stuck (from Oct 2006) →