TL40 Volume Up Button Stuck
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
The Toyota key pad is a resistor-encoded switch, which means that each button has a separate and different value resistor connected to it.The mayday ECU uses a voltage divider circuit to determine which button has been pressed.
The ECU supplies a 12 V signal voltage to the roof console box connector on terminal 2. Whenever a button is pressed, the corresponding switch is closed and is connected to ground through a resistor.
The mayday ECU monitors the voltage which will change when any of the buttons are pressed.
When the Volume Up button is pressed, the voltage on terminal 17 of the mayday ECU unit connector N46 will be approximately 0.7 V. The ECU determines this voltage as a Volume Up button press.
Pressing this button while a call is connected will increase the speaker volume.
DTC TL40 is set if the Volume Up button is pressed for longer than 2 minutes.
INSPECTION PROCEDURE
| 1. CHECK DTCs |
Turn the engine switch on (IG).
Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.
Select: Back / History DTC / Clear Current DTCs.
Turn the engine switch off for 1 minute, then on (IG) again.
Is DTC TL40 reset?
|
|
||||
| YES | |
| 2. CHECK ROOF CONSOLE BOX BUTTON SIGNAL VOLTAGE |
Connect a digital multimeter between roof console box terminal 3 and ground.

Turn the engine switch on (IG).
Press the End Call button and check for voltage.
- OK:
- 0.7 V
|
|
||||
| OK | |
| 3. CHECK BUTTON SUPPLY VOLTAGE |
Disconnect the roof console box connector Q16.

Connect a digital multimeter between terminal 2 and ground.
Turn the engine switch on (IG) and check for voltage.
- OK:
- 12 - 14 V
|
|
||||
| OK | |
| 4. MAYDAY ECU WIRE HARNESS |
Disconnect the mayday ECU connectors A and B.

Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 5. CHECK MAYDAY ECU CONNECTORS |
Are the mayday ECU connectors tight?
|
|
||||
| YES | ||
| ||
