2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. INSTALL MAYDAY ECU UNIT
  1. Install the mayday ECU unit.

  1. Install the 3 reinforcement plates ensuring they are positioned correctly.

  1. Install the 3 nuts.

    Torque:
    7.2 N*m{ 73 kgf*cm , 64 in.*lbf }

  1. Connect the mayday ECU unit connector N46, GPS antenna connector and GSM antenna connector.


2. INSTALL REAR SUNSHADE ASSEMBLY (w/ Rear Sunshade)

HINT:
Follow the steps for installing the rear sunshade assembly (Click here).


3. CONNECT BATTERY
  1. Connect the negative battery cable to the battery.


4. RESET BACK-UP BATTERY TIMER
  1. Use the Diagnostic Tool to reset the back-up battery timer, refer to TDT System Functions (Click here).

    NOTICE:
    Reset the back-up battery only when it is replaced.


5. PLACE MAYDAY ECU IN ACTIVE MODE
  1. Using the diagnostic tool, place the mayday ECU into Active mode, refer to TDT System Functions (Click here).

    NOTICE:
    1. If the mayday ECU Service mode is not disabled, the system will not have full functionality.
    2. If a new mayday ECU has been installed into the vehicle, it must be registered with Toyota Link.

← INSTALLATION (Oct 2006 – May 2009)PRECAUTION (Oct 2006 – May 2009) →