Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009from Jun 2009
DESCRIPTION
When the clearance sonar main switch is turned on, an ON signal is sent to the clearance warning ECU and the indicator on the switch comes on. The clearance sonar system starts operating according to this signal.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT CLEARANCE SONAR MAIN SWITCH ASSEMBLY
Remove the clearance sonar main switch assembly.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
3 (ECU) - 6 (IG)
Switch free (OFF)
10 kΩ or higher
Switch pushed (ON)
Below 1 Ω
NG
REPLACE CLEARANCE SONAR MAIN SWITCH ASSEMBLY
OK
2. CHECK HARNESS AND CONNECTOR (CLEARANCE SONAR MAIN SWITCH - BATTERY)
Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection
Condition
Specified Condition
E73-6 (IG) - Body ground
Engine switch on (IG)
10 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE SONAR MAIN SWITCH)
Disconnect the O30 ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
O30-12 (CLSW) - E73-3 (ECU)
Always
Below 1 Ω
O30-12 (CLSW) - Body ground
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)