2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clearance Warning ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

When the clearance sonar main switch is turned on, power is sent to the clearance warning ECU assembly and the indicator on the switch comes on. The Toyota parking assist-sensor system starts operating according to this signal.

WIRING DIAGRAM

E188905E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT CLEARANCE WARNING ECU ASSEMBLY
  1. Disconnect the O30 connector from the clearance warning ECU assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O30-10 (IG) - O30-21 (E)
    Ignition switch on (IG), clearance sonar main switch on
    11 to 14 V



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE SONAR MAIN SWITCH)
  1. Disconnect the O30 connector from the clearance warning ECU assembly.

  1. Disconnect the E73 connector from the clearance sonar main switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-10 (IG) - E73-3 (ECU)
    Always
    Below 1 Ω
    O30-10 (IG) - Body ground
    Always
    10 kΩ or higher
    O30-21 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT CLEARANCE SONAR MAIN SWITCH ASSEMBLY

  1. B139331E07
    Remove the clearance sonar main switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (ECU) - 6 (IG)
    Clearance sonar main switch off
    10 kΩ or higher
    3 (ECU) - 6 (IG)
    Clearance sonar main switch on
    Below 1 Ω

Text in Illustration 
*1
Component without harness connected
(Clearance Sonar Main Switch Assembly)


NG
REPLACE CLEARANCE SONAR MAIN SWITCH ASSEMBLY
OK


4. CHECK HARNESS AND CONNECTOR (CLEARANCE SONAR MAIN SWITCH ASSEMBLY - BATTERY)
  1. Disconnect the E73 connector from the clearance sonar main switch assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E73-6 (IG) - Body ground
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning Buzzer Circuit (from Jun 2009)Indicator Circuit (from Jun 2009) →