2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clearance Warning Buzzer Circuit

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

This circuit consists of the power source, No. 1 clearance warning buzzer and clearance warning ECU assembly. An ECU-excited type buzzer is used. The battery voltage supplied through the buzzer is grounded inside the clearance warning ECU assembly using a pulsed digital pattern, producing sound. The ECU operates the buzzer using a sound pattern that changes depending on the distance to the obstacle.

WIRING DIAGRAM

E149951E05

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING BUZZER)
  1. Disconnect the O30 connector from the clearance warning ECU assembly.

  1. Disconnect the F45 connector from the No. 1 clearance warning buzzer.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-12 (BBZ) - F45-2
    Always
    Below 1 Ω
    O30-12 (BBZ) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING BUZZER - BATTERY)
  1. Disconnect the F45 connector from the No. 1 clearance warning buzzer.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F45-1 - Body ground
    Ignition switch on (IG)
    11 to 14 V
    F45-1 - Body ground
    Ignition switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT NO. 1 CLEARANCE WARNING BUZZER
  1. Replace the No. 1 clearance warning buzzer (Click here for LHD, Click here for RHD).

    HINT:
    Since the clearance warning buzzer cannot be inspected while it is removed from the vehicle, replace the clearance warning buzzer with a known good one and check that operation returns to normal. This buzzer is an ECU-excited type.

  1. Check the operation of the Toyota parking assist-sensor system.

    HINT:
    Refer to Operation Check (Initial Check) (Click here).

    Result:
    Result
    Proceed to
    Buzzer does not sound
    A
    Buzzer sounds (for LHD)
    B
    Buzzer sounds (for RHD)
    C



B
REPLACE NO. 1 CLEARANCE WARNING BUZZER (for LHD) (Click here)

C
REPLACE NO. 1 CLEARANCE WARNING BUZZER (for RHD) (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Back Sonar Sensor Circuit (from Jun 2009)Clearance Warning ECU Power Source Circuit (from Jun 2009) →