Fuel System
Fuel
PRECAUTION
1. PRECAUTION
(a) Before inspecting and repairing the fuel system, disconnect the cable from the negative battery terminal.
(b) Do not smoke or work near fire when handling the fuel system.
(c) Keep fuel away from rubber or leather parts.
-
2. DISCHARGE FUEL SYSTEM PRESSURE
(a) Remove the rear seat cushion assembly (
Click Here
)
(b) Remove the rear floor service hole cover.
(c) Disconnect the fuel pump connector.
(d) Start the engine.
(e) After the engine stops, turn the ignition switch off.
HINT:
DTC P0171/25 (fuel problem) may be detected.
(f) Crank the engine again. Check the engine does not start.
(g) Remove the fuel tank cap to discharge pressure from the fuel tank.
(h) Disconnect the cable from the negative battery terminal.
(i) Reconnect the fuel pump connector.
(j) Install the rear floor service hole cover.
(k) Install the rear seat cushion assembly (
Click Here
)
-
ON-VEHICLE INSPECTION
1. CHECK FOR FUEL PUMP OPERATION AND FUEL LEAK

(a) Check fuel pump operation.
(1) Connect the intelligent tester to the DLC3.
(2) Turn the engine switch on (IG) and push the intelligent tester main switch on.
NOTICE:
Do not start the engine.
(3) Select the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump /Speed.
(4) Check for pressure in the fuel inlet tube from the fuel line. Check the sound of fuel flowing in the fuel tank can be heard. If no sound can be heard, check the integration relay, fuel pump, ECM and wiring connector.
(b) Check for fuel leaks.
(1) Check there are no fuel leaks anywhere on the system after performing maintenance. If there is a fuel leak, repair or replace parts if necessary.
(c) Turn the engine switch off.
(d) Disconnect the intelligent tester from the DLC3.
-