Brake Fluid
Brake

ON-VEHICLE INSPECTION
1. INSPECT FLUID LEVEL IN RESERVOIR
(a) Check the fluid level.
If brake fluid level is low, check for leakage and inspect the disc brake pad. If necessary, refill the reservoir with brake fluid after repair and replacement.
Fluid:
SAE J1703 or FMVSS No. 116 DOT3
-
BLEEDING
HINT:
If any work is performed on the brake system or if air in the brake lines is suspected, bleed the air from the brake system.
NOTICE:
• Move the shift lever to the P position and apply the parking brake before bleeding the brakes.
• Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.
• If brake fluid leaks onto any painted surface, wash off and remove it completely.
• Do not operate the brake actuator while air is in the brake system or in the brake master cylinder. Doing so may cause air to enter the brake actuator.
• If bleeding the brake actuator is difficult due to air in the actuator, replace it with a new one.
1. FILL RESERVOIR WITH BRAKE FLUID

(a) Fill the reservoir with brake fluid.
Fluid:
SAE J1703 or FMVSS No. 116 DOT3
-
2. BLEED MASTER CYLINDER

(a) Using SST, disconnect the 2 brake lines from the master cylinder.
SST
09023-00101
09023-38201
-

(b) Slowly depress the brake pedal and hold it (*1).
-

(c) Cover the 2 outer holes with fingers, and release the brake pedal (*2).
-
(d) Repeat (*1) and (*2) 3 or 4 times.
-

(e) Using SST, connect the 2 brake lines to the master cylinder.
SST
09023-00101
09023-38201
Torque:
Without SST
20 N*m
(204 kgf*cm,
15 ft.*lbf)
With SST
18 N*m
(183 kgf*cm,
13 ft.*lbf)
NOTICE:
• Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
• This torque value is effective when SST is parallel to a torque wrench.
-
3. BLEED BRAKE LINE

(a) Connect a vinyl tube to the bleeder plug.
-
(b) Depress the brake pedal several times, then loosen the bleeder plug with the pedal depressed (*3).
-

(c) When fluid stops coming out, tighten the bleeder plug, then release the brake pedal (*4).
-
(d) Repeat (*3) and (*4) until all the air in the fluid is completely bled out.
-
(e) Tighten the bleeder plug completely.
Torque:
Front Wheel
12 N*m
(122 kgf*cm,
9 ft.*lbf)
Rear Wheel
11 N*m
(112 kgf*cm,
8 ft.*lbf)
-
(f) Repeat the above procedures for each wheel to bleed the air from the brake line.
-
4. INSPECT FOR FLUID LEAK
5. INSPECT FLUID LEVEL IN RESERVOIR (
Click Here
)