2007 Aurion TRD · Service Manual Brake

Front Brake Flexible Hose

Brake

COMPONENTS
REMOVAL
HINT:
• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. DRAIN BRAKE FLUID
3. REMOVE FRONT BRAKE FLEXIBLE HOSE
(a) Using SST, disconnect the brake line while holding the front brake flexible hose with a wrench.
SST
09023-00101
NOTICE:
• Do not bend or damage the brake line.
• Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting points.
-
(b) Remove the clip.
-
(c) Remove the bolt, and separate the front brake flexible hose and the speed sensor from the shock absorber.
-
(d) Remove the union bolt, the front brake flexible hose and 2 gaskets.
-
INSTALLATION
1. INSTALL FRONT BRAKE FLEXIBLE HOSE
(a) Connect the front brake flexible hose with the union bolt and 2 new gaskets.
Torque:
35 N*m (357 kgf*cm, 26 ft.*lbf)
-
(b) Connect the front flexible hose and the speed sensor to the shock absorber with the bolt.
Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)
NOTICE:
When installing the front brake flexible hose and the speed sensor, the bracket must face toward the exterior of the vehicle.
-
(c) Install the front brake flexible hose with a new clip.
NOTICE:
• When installing the front brake flexible hose, face the identification mark toward the exterior of the vehicle and minimise twisting of the hose.
• Install the clip as far as it will go.
-
(d) Using SST, connect the brake line to the front brake flexible hose while holding the front brake flexible hose with a wrench.
SST
09023-00101
Torque:
Without SST
15 N*m (155 kgf*cm, 11 ft.*lbf)
With SST
14 N*m (143 kgf*cm, 10 ft.*lbf)
NOTICE:
• Do not bend or damage the brake line.
• Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting points.
• Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
• This torque value is effective when SST is parallel to a torque wrench.
-
2. FILL RESERVOIR WITH BRAKE FLUID ( Click Here )
3. BLEED BRAKE LINE ( Click Here )
4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR ( Click Here )
5. INSPECT FOR FLUID LEAK
6. INSTALL FRONT WHEEL