Rear Brake Flexible Hose
Brake
COMPONENTS

REMOVAL
HINT:
• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
3. REMOVE REAR BRAKE FLEXIBLE HOSE

(a) Remove the union bolt, the rear brake flexible hose and 2 gaskets.
-

(b) Remove the bolt and separate the rear brake flexible hose.
-

(c) Using SST, disconnect the brake line while holding the rear brake flexible hose with a wrench.
SST
09023-00101
NOTICE:
• Do not bend or damage the brake line.
• Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting points.
-
(d) Remove the clip.
-
INSTALLATION
1. INSTALL REAR BRAKE FLEXIBLE HOSE

(a) Connect the rear brake flexible hose with the union bolt and 2 new gaskets.
Torque:
35 N*m
(357 kgf*cm,
26 ft.*lbf)
-
(b) Install the rear brake flexible hose with a new clip.
NOTICE:
• When installing the rear brake flexible hose, face the identification mark toward the exterior of the vehicle and minimise twisting of the hose.
• Install the clip as far as it will go.
-

(c) Using SST, connect the brake line to the rear brake flexible hose while holding the flexible hose with a wrench.
SST
09023-00101
Torque:
Without SST
15 N*m
(155 kgf*cm,
11 ft.*lbf)
With SST
14 N*m
(143 kgf*cm,
10 ft.*lbf)
NOTICE:
• Do not bend or damage the brake line.
• Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting points.
• Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
• This torque value is effective when SST is parallel to a torque wrench.
-

(d) Install the rear brake flexible hose to the shock absorber with the bolt.
Torque:
19 N*m
(194 kgf*cm,
14 ft.*lbf)
-
2. FILL RESERVOIR WITH BRAKE FLUID (
Click Here
)
3. BLEED BRAKE LINE (
Click Here
)
4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR (
Click Here
)
5. INSPECT FOR FLUID LEAK
6. INSTALL REAR WHEEL