2007 Aurion TRD · Service Manual Exterior

Rear Spoiler

Exterior

COMPONENTS
REMOVAL
1. REMOVE LUGGAGE COMPARTMENT DOOR COVER
(a) Using a clip remover, remove the 13 clips and luggage compartment door cover.
-
2. REMOVE REAR No.1 SPOILER
(a) Disconnect the wire connector.
-
(b) Remove the 4 nuts.
-
(c) Disengage the 2 clips and carefully remove the rear No. 1 spoiler while peeling off the No. 1 and No. 4 protectors.


-
(d) Remove any remaining protectors from the spoiler and vehicle body.
-
3. REMOVE REAR No.2 SPOILER
(a) Remove the 2 nuts.
-
(b) Remove the rear No. 2 spoiler while carefully peeling off the double sided tape and the No. 5 and No. 7 protectors.


-
(c) Remove any remaining protectors and double sided tape from the spoiler and vehicle body.
-
DISASSEMBLY
1. REMOVE CENTRE STOP LIGHT ASSEMBLY ( Click Here )
REASSEMBLY
1. INSTALL CENTRE STOP LIGHT ASSEMBLY ( Click Here )
INSTALLATION
1. PREPARATION
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
(2) Ensure the protectors and double sided tape are removed from the vehicle body.
(3) Wipe off any tape adhesive residue with cleaner.
-
(b) Clean the rear spoilers. (If reusing the rear spoilers)
(1) Using a heat light, heat the rear spoiler.
(2) Ensure the protectors and double sided tape are removed from the spoiler.
(3) Wipe off any tape adhesive residue with cleaner.
(4) Apply new protectors and double sided tape as required to the spoilers.
-
2. INSTALL REAR NO. 2 SPOILER
(a) Using a heat light, heat the vehicle body and rear spoiler.
-
(b) Remove the release papers from the protectors and double sided tape.
HINT:
After removing the release paper, keep the exposed adhesive free from foreign matter.
-
(c) Install the rear No. 2 spoiler.


-
(d) Install the 2 nuts.
-
3. INSTALL REAR NO. 1 SPOILER
(a) Using a heat light, heat the vehicle body and rear spoiler.
-
(b) Remove the release papers from the protectors.
HINT:
After removing the release paper, keep the exposed adhesive free from foreign matter.
-
(c) Engage the 2 clips and install the rear No. 1 spoiler.


-
(d) Install the 4 nuts.
-
(e) Connect the wire connector.
-
4. INSTALL LUGGAGE COMPARTMENT DOOR COVER
(a) Install the luggage compartment door cover with the 13 clips.
-