DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0010 | Open or short in camshaft timing oil control valve assembly circuit (1 trip detection logic) |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE CAMSHAFT TIMING OIL CONTROL VALVE) |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1).
Check the engine speed while operating the camshaft timing oil control valve assembly using the tester.
| Tester Operation | Specified Condition |
| 0% | Normal engine speed |
| 100% | Engine idles roughly or stalls |
|
| ||||
| OK | ||
| ||
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() |
Remove the camshaft timing oil control valve assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 6.9 to 7.9 Ω |
| *1 | Component without harness connected (Camshaft Timing Oil Control Valve Assembly) |
![]() |
Connect the positive (+) battery terminal to terminal 1 and connect the negative (-) battery terminal to terminal 2. Check the valve operation.
Reinstall the camshaft timing oil control valve assembly.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
Disconnect the camshaft timing oil control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C32-1 - C24-100 (OC1+) | Always | Below 1 Ω |
| C32-2 - C24-123 (OC1-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C32-1 or C24-100 (OC1+) - Body ground | Always | 10 kΩ or higher |
| C32-2 or C24-123 (OC1-) - Body ground | Always | 10 kΩ or higher |
Reconnect the camshaft timing oil control valve assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||