DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Conditions (a) and (b) continue for 2.0 seconds (1 trip detection logic): (a) Throttle actuator duty ratio 80 % or more (b) Throttle actuator current 0.5 A or less |
|
| P2103 | Either of the following conditions is met:
|
|

| 1.INSPECT THROTTLE BODY (RESISTANCE OF THROTTLE CONTROL MOTOR) |
![]() |
Disconnect the C5 throttle body connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M+ (C5-2) - M- (C5-1) | 20°C (68°F) | 0.3 to 100 Ω |
Reconnect the throttle body connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE CONTROL MOTOR - ECM) |
![]() |
Disconnect the C5 throttle body connector.
Disconnect the C58 (RHD) or C55 (LHD) ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| M+ (C5-2) - M+ (C58-19) | Below 1 Ω |
| M- (C5-1) - M- (C58-18) | Below 1 Ω |
| Tester Connection | Specified Condition |
| M+ (C5-2) - M+ (C55-19) | Below 1 Ω |
| M- (C5-1) - M- (C55-18) | Below 1 Ω |
| Tester Connection | Specified Condition |
| M+ (C5-2) or M+ (C58-19) - Body ground | 10 kΩ or higher |
| M- (C5-1) or M- (C58-18) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| M+ (C5-2) or M+ (C55-19) - Body ground | 10 kΩ or higher |
| M- (C5-1) or M- (C55-18) - Body ground | 10 kΩ or higher |
Reconnect the throttle body connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||