Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Voice Guidance does not Function

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK NAVIGATION SETTING


    E181032
  1. Display the "Voice Settings" screen.

  1. Check that "Off" is not selected.

    OK:
    "Off" is not selected.



NG
SELECT VOICE VOLUME SETTING OTHER THAN "Off"
OK


2.CHECK NAVIGATION SETTING


    E181033
  1. Display the "Voice Settings" screen.

  1. Check that "Auto Voice Guidance" is not "Off".

    OK:
    Auto voice guidance is not "Off".



NG
TURN AUTO VOICE GUIDANCE "On"
OK


3.CHECK NAVIGATION SETTING


    E181034
  1. Display the "Voice Settings" screen.

  1. Check that "Voice Guidance in All Modes" is not "Off".

    OK:
    "Voice Guidance in All Modes" is not "Off".



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4.CHECK HARD DISK DRIVE (OPERATION CHECK)


    E181026E02
  1. Display the "Failure Diagnosis" screen (Click here).

  1. Select "HDD Check" and check the result.

    OK:
    "OK" is displayed.

    HINT:
    After "HDD Check" is selected, it may take a while until the result is displayed.

    Text in Illustration 
    *1
    Result



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


5.CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
SET CABIN TO APPROPRIATE TEMPERATURE
OK


6.CHECK AUDIO FUNCTION
  1. Check that audio sound can be heard from the driver side speaker.

    OK:
    Audio sound can be heard.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)