Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Screen Flicker or Color Distortion

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK DISPLAY SETTING


    E181030
  1. Press the "DISP" switch on the panel switch.

  1. Reset display settings (contrast, brightness) and check that the screen appears normally.

    OK:
    The display returns to normal.



NG
Go to step 2
OK

END 

2.CHECK CABIN
  1. Check that the temperature in the cabin is neither -20°C (-4°F) or lower nor 65°C (149°F) or higher.

    HINT:
    The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Temperature in the cabin is between -20°C (-4°F) and 65°C (149°F).



NG
HEAT OR COOL CABIN AND RECHECK TEMPERATURE
OK


3.CHECK COLOR BAR (OPERATION CHECK)


    E176520
  1. Display the "Color Bar Check Mode" screen (Click here).

  1. Check that the color bars match the displayed names.

    OK:
    Color bars match the displayed names.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)