AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION |
| RESET TRANSAXLE COMPENSATION CODE |
Shift the shift lever to the N or P position.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on and push the intelligent tester main switch on.
![]() |
Enter the menu items in this order: Powertrain / ECT / Utility / A/T Code Reset.
Press "Next".
![]() |
Press "Next" again to proceed.
![]() |
Press "Exit".
| PERFORM ROAD TEST TO ALLOW TCM TO LEARN |
From a standstill, achieve highest possible speed with the accelerator pedal opened 15% or less. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
From a standstill, achieve highest possible speed with the accelerator pedal opened 25% or more. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
| RESET MEMORY |
Reset procedure is as follows.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the on position.
Turn the intelligent tester main switch on.
Select the following items: "Powertrain / ECT / Reset Memory".
